how to connect ipod to audioengine d1 dac

Still, 13 years is some solid service.Īnyway, it's time to get a new system! But the thing is, I no longer care about 5.1 or surround, I've seen enough cable spaghetti of 30-foot cables to last a fucking lifetime. It was purchased in 1999 and cost over $2000 USD at the time (christ can't believe my parents paid that much o_O) but now the woofer and small speakers have pretty much begun all to crackle and rattle.although the amplifier is still fully functional, that thing weights over 20kg on it's own and even the inbuilt TV speakers are sounding better now. Smoothly adjust volume levels at fine increments without any undesirable noise or channel imbalance at lower volumes.So yesterday I finally retired our old Sony 5.1 home theater set. Volume for headphones and line-out is controlled directly from the D1 front panel via the digitally-controlled analog potentiometer.

The audio line-out preamp connects to powered speaker systems, amplifiers, or other external decoders with an analog or optical output.

Because of the efficiency of the D1, it can even be powered by a phone or tablet. The D1 is powered directly from the USB input and passed through two stages of regulation to ensure no USB power variations affect the audio quality. The D1 includes the ES9601C SABRE headphone driver amp with circuit protection and is designed for a wide range of headphones that will satisfy even the most critical listeners.

The D1 can process digital audio at any bit depth up to 24-bits and any sample rate up to 96kHz (192kHz using optical) Due to the high signal-to-noise specs of the ES9018 and the added benefit of double redundancy power source conversion and filtering, the D1 presents impressive low noise and low distortion characteristics. The D1 uses the ESS ES9018 DAC, which is well regarded for its low noise and high fidelity. Relative Humidity: 5% to 95% non-condensing Operating Temperature: 32 to 95 degrees F

How to connect ipod to audioengine d1 dac